Rohde & Schwarz SMIQ02B - Page 196

SMIQ Digital Standard PHS
1125.5555.03 E-92.127
(SELECT SLOT) BURST TYPE...
Opens a window for the selection of the burst type used
to configure the selected slot.
TCH_FULL Traffic channel configuration (rate 32 kbit/s)
IEEE-bus
:SOUR:PHS:SLOT2:TYPE TCHF
TCH_HALF Traffic channel configuration (rate 16 kbit/s)
IEEE-bus
:SOUR:PHS:SLOT2:TYPE TCHH
VOX VOX configuration. In slots 4 to 8 (uplink)
transmission is only in every fourth frame.
IEEE-bus
:SOUR:PHS:SLOT2:TYPE VOX
SYNC Sync burst
IEEE-bus
:SOUR:PHS:SLOT2:TYPE SYNC
ALL DATA Burst type for testing with freely
programmable data contents
IEEE-bus
SOUR:PHS:SLOT2:TYPE ADAT
SLOT LEVEL
Selection of level for selected slot.
OFF Maximum attenuation
IEEE bus
:SOUR:PHS:SLOT2:LEV OFF
FULL The level corresponds to the value indicated
on the SMIQ LEVEL display.
IEEE bus
:SOUR:PHS:SLOT2:LEV FULL
ATTEN The level is reduced by the value set under
SLOT ATTENUATION.
IEEE bus
:SOUR:PHS:SLOT2:LEV ATT
SET DEFAULT
Resets the subsequent parameters to the factory-set
values.
IEC/IEEE-bus command
:SOUR:PHS:SLOT8:PRES
CS-ID SCRAMBLE
STATE
Switch on/off of CS-ID scrambling function.
IEC/IEEE-bus
:SOUR:PHS:SLOT2:SCR:STAT ON
CS-ID CODE
Input value in hexadecimal form for initializing the
scramble generator.
IEEE-bus
:SOUR:PHS:SLOT2:SCR:CODE #H123
ENCRYPTION
STATE
Switch on/off of encryption scrambling function. This
parameter is only available for TCH burst types.
IEC/IEEE-bus
:SOUR:PHS:SLOT2:ENCR:STAT ON
SECURITY KEY
Input value in hexadecimal form for initializing the
scramble generator. This parameter is only available for
TCHburst types.
IEEE-bus
:SOUR:PHS:SLOT2:ENCR:KEY #H1234