Digital Standard W-CDMA (NTT DoCoMo/ARIB 0.0) SMIQ
1125.5555.03 E-92.162
TYPE
Opens a window for selecting the channel type.
PERCH Perch 1-channel with Pilot, DATA and LMS data field. Selection is
possible with LINK DIRECTION - DOWN.
CCPCH Common Control Physical Channel with Pilot and DATA field.
Selection is possible with LINK DIRECTION - DOWN and UP.
DPCH Dedicated Control Physical Channel with Pilot, TPC and DATA
field. Selection is possible with LINK DIRECTION - DOWN and UP.
ALLD All data channel type only with DATA field. Selection is possible
with LINK DIRECTION - DOWN and UP.
IEC/IEEE-bus command :SOUR:WCDM:CHAN4:DPCH
SYMBOL RATE
Opens a window for selecting the symbol rate. The admissible selection
depends on the channel type selected (TYPE). The possible values are
represented in the following table:
TYPE SYMBOL RATE
kS/s
PERCH 16
CCPCH 64
DPCH 32, 64, 128, 256, 512, 1024
DPDCH 16, 32, 64, 128, 256, 512, 1024
DPCCH 16
ALLD 16, 32, 64, 128, 256, 512, 1024
IEC/IEEE-bus command :SOUR:WCDM:CHAN4:SRAT D64
Menu selection: DIGITAL STD - WCDMA - SPREAD CODE
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
WCDMA
PHS
IS-95
WCDMA
NADC
PDC
GSM
DECT
CLOCK
TOTAL
ADJUST TOTAL
SAVE/RECALL
MULTICODE..
SEQUENCE LE
___________
CHNO TYPE
0 PERCH
1 DPCH
2 DPCH
SPREADING OF CHANNEL 1
SHORT CODE 10
LONG CODE INIT 00001 H
LONG CODE OFFSET 0 Chip
LEVEL
-30.0
dBm
PEP
- 14.9
dBm
Fig. 2-94 Menu DIGITAL STD - WCDMA - SPREAD CODE; equipped with options modulation coder
SMIQB20, data generator SMIQB11 and SMIQB43
SPREAD CODE
Opens a window for the spread code settings. The first line of the window
indicates the code channel for which the settings are done (SPREADING OF
CHANNEL NO).
To Next Page
Loading...
