SMIQ Digital Standard W-CDMA (NTT DoCoMo/ARIB 0.0)
1125.5555.03 E-92.163
(SPREAD CODE) SHORT CODE Entry value for the short code index. The upper limit
depends on parameters CHIP RATE, SYMBOL RATE
as well as on the channel type.
IEC/IEEE :SOUR:WCDM:CHAN4:SCOD 12
LONG CODE INIT Entry value for initializing the long code generator in
hexadecimal notation.
IEC/IEEE :SOUR: WCDM:CHAN4:LCOD #HFFF
LONG CODE OFFSET Entry value for a time shift of the long code with
respect to the data symbols in units of chip duration.
IEC/IEEE :SOUR:WCDM:CHAN4:LCOD:OFFS 1
LMS SHORT CODE Entry value for the short code index used for
spreading the long code mask symbols (LMS) of the
Perch channel.
IEC/IEEE :SOUR:WCDM:CHAN4:SCOD:LMS #HFF
POWER
Input value for channel power.
POWER indicates the average power of the code channel relative to the
power indicated in LEVEL display (code domain power).
For MODE - 4CHAN
- the power of channels 0, 1, 2 and 3 is set separately.
For MODE - 8CHAN
- the power of channel 0 is set separately.
- the other channels have the same power. The power for all the channels is
set, for instant, in channel 1.
For MODE - 15CHAN
- Since all channels have the same power, they cannot be set. POWER is
only a display parameter in this case.
When this value is modified, the value of TOTAL POWER is automatically adapted.
IEC/IEEE-bus command :SOUR:WCDM:CHAN4:POW -3
Menu selection: DIGITAL STD - WCDMA - DATA
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
WCDMA
PHS
IS-95
WCDMA
NADC
PDC
GSM
DECT
CLOCK
TOTAL
ADJUST TOTAL
SAVE/RECALL
MULTICODE..
SEQUENCE LE
___________
CHNO TYPE
0 PERCH
1 DPCH
2 DPCH
DATA CONFIGURATION OF CHANNEL 1
DATA PN15
DATA OFFSET 3 Symb
TPC ALT
LEVEL
-30.0
dBm
PEP
- 14.9.
dBm
Fig. 2-95 Menu DIGITAL STD - WCDMA - DATA; equipped with options modulation coder SMIQB20,
data generator SMIQB11 and SMIQB43
To Next Page
Loading...
