Rohde & Schwarz SMIQ02B - Menu W-CDMA Standard - Uplink Signals with IQ Multiplex

SMIQ Digital Standard W-CDMA (NTT DoCoMo/ARIB 0.0)
1125.5555.03 E-92.165
2.13.5 Menu W-CDMA Standard - Uplink Signals with IQ Multiplex
The settings for generating W-CDMA signals can be accessed via the menu DIGITAL STD - W-CDMA.
The figure below shows the menu for generating the uplink signal with multiplex mode for the I and Q
channel in the 8CHAN mode. The previous section shows the menu for generating the up and downlink
signals without IQ multiplex as well as the parameters which are identical for all modes.
Selection: DIGITAL STD - WCDMA- MODE -8CHAN, -LINK DIRECTION/MULTIPLEX - UP_IQ_MULT
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
WCDMA
PHS
IS-95
WCDMA
NADC
PDC
GSM
DECT
STATE
MODE 4CHAN 8CHAN 15CHAN
SET DEFAULT
CHIP RATE 4.096 Mcps
LINK DIRECTION/MULTIPLEX UP_IQ_MULT
MODULATION... QPSK
TRIGGER MODE... RETRIG
EXECUTE TRIGGER
TRIGGER.... INT
CLOCK... INT EXT
TOTAL POWER 0.0 dB
ADJUST TOTAL POWER
SAVE/RECALL SETTINGS... COMING SOON
MULTICODE... OFF
SEQUENCE LENGTH (FRAMES) 1
_________SYMB RATE SPREAD POWER_______________
CHNO TYPE [ks/s] CODE [dB] DATA STATE
0I DPDCH 16 1 -11.8 PN15 OFF
0Q DPCCH 16 0 -11.8 PN15 ON
1I DPDCH 16 8 -11.8 PN15 ON
1Q DPDCH 16 8 -11.8 PN15 ON
2I DPDCH 16 9 -11.8 PN15 ON
2Q DPDCH 16 9 -11.8 PN15 ON
3I DPDCH 16 10 -11.8 PN15 ON
3Q DPDCH 16 10 -11.8 PN15 ON
4I DPDCH 16 11 -11.8 PN15 ON
4Q DPDCH 16 11 -11.8 PN15 ON
...
7I DPDCH 16 14 -11.8 PN15 ON
7Q DPDCH 16 14 -11.8 PN15 ON
OFF ON
LEVEL
-30.0
dBm
PEP
- 14.9.
dBm
Fig. 2-96 Menu DIGITAL STD - WCDMA - MODE - 8CHAN, -LINK DIRECTION/MULTIPLEX -
UP_IQ_MULT, equipped with options modulation coder SMIQB20, data generator
SMIQB11 and SMIQB43
Parameters STATE to SEQUENCE LENGTH see section " Menu W-CDMA Standard -Downlink and
Uplink Signals without IQ Multiplex"