Digital Standard 3GPP W-CDMA (FDD) SMIQ
1125.5555.03 E-92.180
Fig. 2-105 DIGITAL STD - WCDMA/3GPP menu – progress bar
SET DEFAULT
Sets the default setup for 3GPP W-CDMA.
For further information about the default setting see section 2.14.2.12.
IEC/IEEE-bus command :SOUR:W3GP:PRES
SAVE/RECALL...
The SMIQ supports two parallel SAVE/RECALL memory systems: The SAVE
and RCL hardkeys are used to handle the frequency, level and state in the
3GPP W-CDMA menu. Menu selection SAVE/REALL, however, manages all
the other parameters in the 3GPP W-CDMA menu. This also includes station-
specific parameters such as the channel table.
RECALL SETTING Recalling a saved configuration.
IEC/IEEE bus :SOUR:W3GP:SETT:LOAD "MYSETUP"
SAVE SETTING Saving the current configuration.
An existing setting can be overwritten or a new setting
can be created. The name of the new setting is assigned
automatically, e.g. WCDMASEQ1.
If the setting is created via the IEC/IEEE bus, the name
is user-selectable and the usual restrictions apply.
IEC/IEEE bus :SOUR:W3GP:SETT:STOR "MYSETUP"
DELETE SETTING Deleting a configuration.
IEC/IEEE bus :SOUR:W3GP:SETT:DEL "MYSETUP"
Selection of one of the test models defined in the 3GPP standard [3]. This menu
item is available only in the downlink. The following test scenarios are available:
Test Model Application/measurement
Test1_16
TEST MODEL 1 (16 channels)
Spectrum emission mask
ACLR
Spurious emissions
Transmit intermodulation
Modulation accuracy
Peak code domain error
TEST MODELS
Test1_32
TEST MODEL 1 (32 channels)
Spectrum emission mask
ACLR
Spurious emissions
Transmit intermodulation
Modulation accuracy
To Next Page
Loading...
