Enhanced Functions For Digital Standard 3GPP W-CDMA (FDD) SMIQ
1125.5555.03 2.250 E-9
----------------------Specific Enhanced Channel Settings--------------------------------------------------
CHANNEL NUMBER
Display parameter for the assigned serial number of a downlink enhanced
DPCH or an uplink enhanced DPDCH from the BS1 or MS1 channel table.
The enhanced channels are assigned to the first 4 dedicated channels in the
BS1 channel table or to the DPCCH/DPDCH of the MS1 channel table.
With Enhanced P-CCPCH/BCH State On in the downlink, also the P-CCPCH
with channel number 4 is available.
STATE
Switch for activating or deactivating the corresponding downlink enhanced
channel. In the ON state the channel is marked as enhanced channel by an
additional E (in addition to CH. NO) in the channel table line determined by the
CHANNEL NUMBER in the higher BS1 menu – under the precondition that the
ENHANCED CHANNELS STATE switch is set to ON.
In the OFF state, the following channel-specific menu parameters are not
effective:
CHAN CODE
POWER START
POWER CONTROL
DATA
TPC
MULTI CODE
In the higher BS1 menu, the STATE parameter has to be updated in the
channel table line determined by the ENHANCED CHANNEL NUMBER.
Note: The enhanced channels cannot be activated individually in the
uplink; the required enhanced channels are automatically activated
via the OVERALL SYMBOL RATE setting.
IEC/IEEE-bus command :SOUR:W3GP:BST:ENH:CHAN11:STAT ON
TYPE
Display parameter for the channel type of the corresponding enhanced
channel.
The type is taken from the TYPE parameter of the channel table line or
column determined by the ENHANCED CHANNEL NUMBER with the channel
table belonging to the higher BS1/MS1 menu.
In the downlink, enhanced channels have the DPCH type and in the uplink, the
DPCCH type (1st enhanced channel) or DPDCH (2nd to 4th enhanced
channel).
With Enhanced P-CCPCH/BCH State On in the downlink, channel type
P-CCPCH is additionally available in the table.
To Next Page
Loading...
