Rohde & Schwarz SMIQ02B - Page 367

Digital Standard PDC SMIQ
1125.5555.03 2.298 E-9
Menu selection: BURST TYPE = VOX (only available with LINK DIRECTION = UPLINK)
FREQ
100. 000 000 0
MHz
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
PDC
PHS
IS95
NADC
PDC
GSM
SLOT G R P SYNC CC SF SACCH G2
0 UP 108 4 6 20 8 1 15 118
BURST TYPE... VOX
SLOT LEVEL OFF ATTEN FULL
SET DEFAULT
SCRAMBLE STATE OFF ON
SCRAMBLE START 001 H
SUPER FRAME OFF ON
RCH POSITION 1
------------------BURST CONTENTS----------------
G 000 0000 0000 0000 0000 0000 0000 H
R0H
P26H
SYNC 7 85B4 H
SYNC2 C E450 H
CC 00 H
SF 0 H
SACCH PN9
RCH PN9
G2 00 0000 0000 0000 0000 0000 0000 0000 H
-------------------CHANGE DATA------------------
SELECT DATA LIST... CURRENT: R&STDM
COPY CURRENT DATA LIST...
DELETE DATA LIST...
EDIT DATA LIST...
LEVEL
-30.0
dBm
PEP
- 27.4
dBm
POWE
SLOT
SAVE
LINK
RATE
SELE
EDIT
0
VO
Fig. 2-194 Menu DIGITAL STD - PDC - SELECT SLOT, LINK DIRECTION = UPLINK, SMIQ
equipped with Modulation Coder SMIQB20 and Data Generator SMIQB11
(SELECT SLOT...)
VOX
(UPLINK ONLY)
BURST TYPE
Selection of burst type used to configure the selected slot.
VOX is only available with LINK DIRECTION = UPLINK
selected.
VOX VOX burst
IEC/IEEE-bus command
:SOUR:PDC:SLOT2:TYPE VOX
SLOT LEVEL
Selection of level for selected slot.
OFF Maximum attenuation
IEC/IEEE
:SOUR:PDC:SLOT2:LEV OFF
FULL The level corresponds to the value indicated on
the SMIQ LEVEL display.
IEC/IEEE
:SOUR:PDC:SLOT2:LEV FULL
ATTEN The level is reduced by the value set under
SLOT ATTENUATION.
IEC/IEEE
:SOUR:PDC:SLOT2:LEV ATT