Rohde & Schwarz SMIQ02B - Voltage Indication of Test Points (DIAG-TPOINT)

SMIQ Utilities
1125.5555.03 2.425 E-9
2.29.11 Voltage Indication of Test Points (DIAG-TPOINT)
Submenu DIAG-TPOINT offers access to internal test points. If a test point is switched on, the voltage
indication is displayed in a window in the header field. For greater detail, see service manual.
Menu selection: UTILITIES - DIAG - TPOINT
SYSTEM
REF OSC
PHASE
PROTECT
CALIB
DIAG
TEST
MOD KEY
AUX I/O
BEEPER
INSTALL
CONFIG
TPOINT
C/NMEAS
PARAM
FREQ
100. 000 000 0
MHz
OFF ON
7
STATE
POINT
LEVEL
-30.0
dBm
TP 007
+3.570V
FREQUENCY
LEVEL
ANALOG MOD
VECTOR MOD
DIGITAL MOD
DIGITAL STD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
Fig. 2-269 Menu UTILITIES - DIAG - TPOINT
STATE
Switching on/off the voltage indication in the header field.
POINT...........
Input value of the test point.
IEC/IEEE-bus command :DIAG:POINxx?