Rohde & Schwarz SML01 - Source:stereosubsystem

SOURce:STEReo R&S®SML / R&S®SMV03
1090.3123.12 E-6 6.34
SOURce:STEReoSubsystem
This subsystem contains the commands to control the stereo modulation, the ARI functions and basic
RDS functions. and to set the parameters of the modulation signal. All RDS functions of the
Stereo/RDS coder can be set by means of
[SOURce]:STEReo:DIRect: "string"
Queries are formed as follows:
[SOURce]:STEReo:DIRect? ["string"]
Command Parameters Default
Unit
Remark
[:SOURce]
:STEReo
:ARI
:BK
[:CODE]
[:DEViation]
:STATe
:TYPE
:STATe
A | Bl | C | D | E | F
0 ... 10 kHz
ON | OFF
DK | BK | BKDK
ON | OFF
Hz
:AUDio
[:FREQency]
:MODE
:PREemphasis
:STATe
0,1 Hz ... 1MHz
LEFT | RIGHt | RELeft | REMLeft| RNELeft
50 us | 75 us
ON | OFF
Hz
s
:EXTernal
:IMPedance
600 Ohm | 100 kOhm Ohm
[:DEViation]
0 ... 80 kHz Hz
:DIRect
'String'
:PILot
[:DEViation]
:PHAse
:STATe
0 ... 10 kHz
-5 ... 5 DEG
ON | OFF
Hz
DEG
:RDS
:DATaset
[:DEViation]
:STATe
:TRAFfic
:PROGram
:[STATe]
:ANNouncement
:[STATe]
DS1 | DS2 | DS3 | DS4 | DS5
0 ... 10 kHz
ON | OFF
ON | OFF
ON | OFF
Hz
:SOURce
LREXt | SPEXt | LFGen
:STATe
ON | OFF