Manual Operation
R&S
®
SMU200A
109Operating Manual 1007.9845.32 ─ 15
Auxiliary functions are offered in the lower editor area, e.g. presetting for the ramps in
the marker signal, cursor positioning by entering the bit position and possible editing by
means of value entries in a table.
The actual graphic definition of the control signals occurs in the center area of the editor.
Each control signal is represented by means of a colored line along the bit axis. A cursor
can be shifted alongside this line and marks the position where a ramp is to be set. The
color of the cursor changes depending on the current function.
Use the ENTER key to switch over between the colors (and therefore functions):
●
black: marks the bit position on the marker line
●
yellow: sets a ramp
●
green: activates the marked ramp for shifting.
Accessing control and marker list
1. To access the control list editor (e.g. "CList Dig Mod") and open an existing list for
editing, use the arrow keys to select "Custom Digital Mod > List Management > Edit
Control List".
2. To access the slot marker list editor (e.g. "Slot Marker") and open an existing list for
editing, use the arrow keys to select "GSM/EDGE > Burst Editor > Slot Marker Def-
inition".
Editing an existing control or marker list
1. Activate control/marker signal line for editing.
Use the arrow keys to mark the editable graphic area and press the ENTER key.
Select the control/marker signal line to be edit and press the ENTER key.
The cursor is active for the selected line.
2. Define the cursor position.
Select the parameter "Cursor Position", specify the position by means of the numeric
keys and confirm the entry.
The cursor is positioned according to the entry. If the entered value exceeds the
selected length of the definition range, the length is adjusted automatically.
Editors
To Next Page
Loading...
