Instrument Function
R&S
®
SMU200A
145Operating Manual 1007.9845.32 ─ 15
LAN Status
The LED indicates the LXI status.
The LAN Status is also indicated with the LED "LAN Status" on the front panel of the
instrument.
"green"
normal operation
"green (flash-
ing"
device identification
"red"
LAN fault
SCPI command:
n.a.
LAN Reset
Initiates the network configuration reset mechanism for the instrument and resets the
hostname, MAC address, and IP address.
Alternatively, the LAN RESET button on the front panel of the instrument can be used.
To initiate the network configuration reset, press the button longer than 4 sec and wait
for the signal tone.
According to the LXI standard, an LAN Reset must place the following network settings
to a default state:
Parameter Value
TCP/IP Mode DHCP + Auto IP Address
Dynamic DNS Enabled
ICMP Ping Enabled
Password for LAN configuration LxiWebIfc
The LAN Reset for the R&S Signal Generator also resets the following parameters:
Parameter
Hostname
Instrument-specific host name
Description Vector Signal Generator
General Instrument Settings
To Next Page
Loading...
