Rohde & Schwarz SMU200A - Page 167

Instrument Function
R&S
®
SMU200A
147Operating Manual 1007.9845.32 ─ 15
A change of passwords for the operating system and security password requires the entry
of the old and new password and the conformation of the new password. All settings are
only accepted after the "Change Password" button is pressed.
Old Password (Security Password)
Enters the currently used security password. The default password is '123456'.
Note: It is highly recommended to change the default security password before connect-
ing the instrument to the network.
The security password is required when changing the status of the USB and LAN inter-
face.
SCPI command:
n.a.
New Password (Security Password)
Enters the new security password.
The security password may contain decimal characters only.
SCPI command:
n.a.
Confirm Password (Security Password)
Enters the new password for conformation.
The new password is only valid after the "Change Password" button is pressed.
SCPI command:
n.a.
Change Password (Security Password)
Changes the password accordingly.
SCPI command:
n.a.
USB Device
Enables/disables the USB interfaces.
General Instrument Settings