Instrument Function
R&S
®
SMU200A
164Operating Manual 1007.9845.32 ─ 15
State
Activates the selected graphical display.
After activation, the diagram selected with "Mode" is displayed in the block diagram.
At the bottom of each graphics window there are several buttons for freezing and zooming
the display and for activating a reference curve.
For more information, see chapter 5.3.2, "Bar of Graphics Window", on page 166.
SCPI command:
[:SOURce<hw>]:BB:GRAPhics:STATe on page 658
Smart Graphics
Activates the "smart graphics".
The graphic is displayed in a small window which is roughly the size of a block. These
windows are displayed permanently in the block diagram until they are deactivated, and
allow basic checking of the signal. They do not contain any buttons.
SCPI command:
[:SOURce<hw>]:BB:GRAPhics:SMARt:STATe on page 657
Mode
Selects the graphical signal display. The display is not shown until it has been activated
with "Status On".
The individual signal displays are described in the chapter 5.3.3, "Signal Displays",
on page 168.
SCPI command:
[:SOURce<hw>]:BB:GRAPhics:MODE on page 657
Trigger Source
Defines the trigger for the starting time of the graphic recording.
"Software"
Recording of signals is started automatically in specified intervals.
This asynchronous method is appropriate when a representative display
of the complete signal is desired, as recording starts in a random time
reference to the signal.
Graphical Display - Graphics
To Next Page
Loading...
