Rohde & Schwarz SMU200A - Filling the List Mode Data Automatically

Instrument Function
R&S
®
SMU200A
274Operating Manual 1007.9845.32 ─ 15
Select ASCII Source / Destination - List Mode
Calls the "File Manager" for selecting the ASCII file to be imported into a list mode list
(source) or the ASCII file the list mode list is exported (destination) in.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:AFILe:SELect on page 751
Destination / Source - List Mode
Calls the "File Manager" for selecting the list mode list to be exported (source) into an
ASCII file or the destination for the ASCII file to be imported (destination) in.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:SELect on page 753
Import / Export - List Mode
Starts the export or import of the selected file.
When import is selected, the ASCII file is imported as list mode list.
When export is selected, the list mode list is exported into the selected ASCII file.
SCPI command:
[:SOURce<hw>]:LIST:DEXChange:EXECute on page 752
5.5.14.2 Filling the List Mode Data automatically
The "Fill List Mode Data" menu enables you to automatically set the values in the List
Mode table.
The start line and the number of rows to be filled are defined under "From" and
"Range".
The column to be filled is selected under "Select column to fill". Depending on the selec-
tion here, the default for start, end, and increment value are set. As the settings are
interdependent, a change of one parameter may result in the automatic change of one
or more of the other parameters.
The filling of the column with the selected value settings is started with button "Fill".
The list entries are only computed when the "Fill" button is pressed.
RF Signal and Analog Modulations - RF Block