Rohde & Schwarz SMU200A - Page 319

Instrument Function
R&S
®
SMU200A
299Operating Manual 1007.9845.32 ─ 15
Correction File Info - I/Q Impairments (Digital Baseband)
Displays the most important header information on the loaded frequency response cor-
rection file.
"Type"
Displays the type of the baseband frequency response correction data.
SCPI command:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:TYPE
on page 666
"Accuracy"
Displays the accuracy of the baseband frequency response correction
data.
SCPI command:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:ACCuracy
on page 661
"Frequency
Range"
Displays the frequency range (maximum and minimum frequency val-
ues) of the baseband frequency response correction data.
SCPI command:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:FREQuency:
MAX on page 664
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:FREQuency:
MIN on page 664
"Level Range"
Displays the level range (maximum and minimum level values) of the
baseband frequency response correction data.
SCPI command:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:LEVel:MAX
on page 665
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:LEVel:MIN
on page 666
"Include ATT
Fixed"
Displays the status of the attenuator, included in the frequency response
correction data. When the operating mode Fixed is switched on, the
attenuator is fixed in its current position and the resulting variation range
is defined.
SCPI command:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:IAFixed
on page 665
Impairment of Digital I/Q Signal and Noise Generator - AWGN/IMP Block