Instrument Function
R&S
®
SMU200A
314Operating Manual 1007.9845.32 ─ 15
If an "R&S EX-IQ-Box" is connected the R&S SMU recognizes this module automatically.
Then, the button "EX-I/Q-Box Settings..." is displayed in the "Digital I/Q Output Set-
tings" dialog for configuring the parameters of the R&S EX-IQ-Box (see "R&S EX-IQ-
BOX" Manual). Additionally the components of the recognized R&S EX-IQ-Box are listed
in the Hardware Config, section Baseband Assembly.
Digital I/Q Output General Settings
State - Digital I/Q Output
Switches On/Off the digital I/Q output signal.
"On"
Switches on the digital I/Q output signal of the currently selected path.
"Off"
Switches off the I/Q output signal of the currently selected path.
SCPI command:
[:SOURce<hw>]:IQ:OUTPut:DIGital:STATe on page 738
EX-I/Q-Box Settings… - Digital I/Q Output
(With a connected R&S EX-IQ-Box only)
Opens the main settings dialog of the R&S EX-IQ-BOX.
SCPI command:
n.a.
Impairment of Digital I/Q Signal and Noise Generator - AWGN/IMP Block
To Next Page
Loading...
