Instrument Function
R&S
®
SMU200A
359Operating Manual 1007.9845.32 ─ 15
Power Ramp Control - Digital Modulation
Calls the power ramp control menu (see chapter 5.8.3.6.11, "Power Ramp Control",
on page 366).
SCPI command:
n.a.
Trigger/Marker - Digital Modulation
Calls the "Trigger/Marker/Clock" menu. The "Trigger/Marker/Clock" menu is used to
select the trigger source, set the time delay on an external trigger signal and configure
the marker output signals (see chapter 5.8.3.6.12, "Trigger/Marker/Clock",
on page 369).
SCPI command:
n.a.
Execute Trigger - Digital Modulation
Executes trigger manually. A manual trigger can be executed only when an internal trig-
ger source and a trigger mode other than Auto have been selected.
SCPI command:
[:SOURce<hw>]:BB:DM:TRIGger:EXECute on page 627
Clock - Digital Modulation
Calls the "Trigger/Marker/Clock" menu. The "Trigger/Marker/Clock" menu is used to
select the clock source (see chapter 5.8.3.6.12.4, "Clock Settings", on page 375).
SCPI command:
n.a.
List Management
The "List Management" menu is called from the "Custom Digital Modulation" main menu.
The data and control lists are selected and created in the "File Select" menu which is
called up by means of the "Data List..." and "Control List..." buttons.
The "File Manager" is used to copy, rename and delete files and to create directories.
Baseband Signal - Baseband Block
To Next Page
Loading...
