Instrument Function
R&S
®
SMU200A
366Operating Manual 1007.9845.32 ─ 15
The ramps of the selected signal can be edited in the table. When the table is opened,
the current configuration of the selected marker/control signal is displayed.
The bit position is specified in the "Ramp Position" column, the high or low signal status
in the "Ramp State" column. At the end of the list, there is always a blank row for entering
new values.
The changes are accepted in the graphic display after pressing the "Accept" button.
SCPI command:
n.a.
Zoom/Visible - Digital Modulation
Zooms the displayed area of the control list. The designation of the button changes from
"Zoom in" to "Zoom out".
With long control lists, the displayed area can be zoomed around the current "Cursor
Position".
Parameter "Visible/Bits Visible" determines the number of symbols/bits to be displayed.
Ramps outside the displayed area are not lost by zooming.
SCPI command:
n.a.
Save/Save As - Digital Modulation
Pressing the "Save" button saves the changes made to the CList file selected for editing.
Selecting the "Save As" button creates a new control list. This opens the "Create Lists
Files Which Name?" window in which the control list can be created.
The file name has to be entered in field "File Name."
SCPI command:
n.a.
Power Ramp Control
The Power Ramp Control menu is accessed via the "Custom Digital Modulation" main
menu.
Baseband Signal - Baseband Block
To Next Page
Loading...
