Instrument Function
R&S
®
SMU200A
382Operating Manual 1007.9845.32 ─ 15
Set To Default
Calls default settings. The values are shown in the table 5-12.
Table 5-12: Default Settings
Parameter Value
State Off
Clock Freq. 1 MHz
Trigger Mode Auto
Trigger Source Internal
Marker State Off
Marker Mode Unchanged
Clock Source Internal
SCPI command:
[:SOURce<hw>]:BB:ARB:PRESet on page 581
Load Waveform
Calls the "File Select "menu for loading the waveform file.
The files last used are listed in the "Recent Data Sets" section. The directory can be
selected from the center left section. All waveform files (file extension *.wv) available
from the selected directory are listed on the right side. The file info (tag contents and multi
segment state) for the selected file is displayed below the file section.
The "Select..." button selects the marked file. This file is loaded when the ARB modulation
is enabled ("State On").
The "File Manager..." button leads to the file manager.
SCPI command:
[:SOURce<hw>]:BB:ARB:WAVeform:SELect on page 614
Waveform Info
Opens a dialog with detailed information about the currently selected waveform.
Baseband Signal - Baseband Block
To Next Page
Loading...
