Rohde & Schwarz SMU200A - Page 404

Instrument Function
R&S
®
SMU200A
384Operating Manual 1007.9845.32 ─ 15
When intending to work with an external clock source, the frequency to be applied must
be entered here.
SCPI command:
[:SOURce<hw>]:BB:ARB:CLOCk on page 582
Trigger/Marker
Calls the Trigger and Marker menu.
This menu is used to select the trigger source, set the time delay on an external trigger
signal and configure the marker output signals (see chapter 5.8.4.1.2, "Trigger/Marker/
Clock Settings", on page 385).
SCPI command:
n.a.
Execute Trigger
Executes trigger manually. A manual trigger can be executed only when an internal trig-
ger source and a trigger mode other than Auto are selected.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:SOURce on page 589
[:SOURce<hw>]:BB:ARB[:TRIGger]:SEQuence on page 591
[:SOURce<hw>]:BB:ARB:TRIGger:EXECute on page 584
Clock
Calls the "Clock" menu. The "Clock" menu is used to select the clock source (see chap-
ter 5.8.4.1.2.5, "Clock Settings", on page 397).
SCPI command:
n.a.
Create Test Signal...
Selects the form of the test signal and calls the menu for generating it. A sinusoidal,
rectangular or test signal with constant I/Q can be selected.
See the corresponding section for detailed description of the parameters for the selected
test signal:
●
chapter 5.8.4.1.3, "Sine Test Signals", on page 398
●
chapter 5.8.4.1.4, "Rect Test Signal", on page 399
●
chapter 5.8.4.1.5, "Const IQ Test Signal", on page 400
SCPI command:
n.a.
Multi Segment
Calls the menu for calculating multi segment waveforms (see chapter 5.8.4.2, "Multi
Segment Waveforms", on page 401).
SCPI command:
n.a.
Baseband Signal - Baseband Block