Instrument Function
R&S
®
SMU200A
398Operating Manual 1007.9845.32 ─ 15
Global Settings
The buttons in this section lead to submenu for general trigger, clock and mapping set-
tings.
Global Trigger/Clock Settings
Calls the "Global Trigger/Clock/Input Settings" dialog.
This dialog is used among other things for setting the trigger threshold, the input impe-
dance and the polarity of the clock and trigger inputs.
In the case of two-path instruments, these settings are valid for both paths.
The parameters in this menu affect all digital modulations and standards, and are descri-
bed in chapter 5.2.3.10, "Global Trigger/Clock/External Input Settings", on page 137.
User Marker / AUX I/O Settings
Calls the "User Marker AUX I/O Settings" menu, used used to map the connector on the
rear of the instruments.
See also chapter 5.2.3.12, "User Marker / AUX I/O Settings", on page 140.
Sine Test Signals
To access the "Sine Test Signals" dialog, in the "ARB MOD" dialog set the parameter
"Create Test Signal" to Sine and press "Create Test Signal".
The menu can be used to configure a sinusoidal test signal. A sine wave is generated on
the I path, and a sine wave of the same frequency but phase-shifted is generated on the
Q path.
The signal actually set is displayed in graphical form in the center of the menu.
Baseband Signal - Baseband Block
To Next Page
Loading...
