Instrument Function
R&S
®
SMU200A
399Operating Manual 1007.9845.32 ─ 15
Frequency (Sine Test Signal)
Enters the frequency of the test signal.
SCPI command:
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:FREQuency on page 596
Samples per Period (Sine Test Signal)
Enters the number of sample values required from the sine wave per period.
The resulting clock rate must not exceed the maximum ARB clock rate (see data sheet).
The number of sample values is automatically restricted by reference to the set fre-
quency.
SCPI command:
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:SAMPles on page 597
Phase Offset Q (Sine Test Signal)
Enters the phase offset of the sinewave signal on the Q channel relative to the sinewave
signal on the I channel.
SCPI command:
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:PHASe on page 597
Generate Signal HD (Sine Test Signal)
Generates a signal and saves it to a file.
The File Select window opens automatically and the signal can be stored as a waveform
file.
SCPI command:
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate:NAMed on page 595
Generate Signal RAM (Sine Test Signal)
Generates a signal and uses it as output straight away.
SCPI command:
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate on page 594
Rect Test Signal
To access the "Sine Test Signals" dialog, in the "ARB MOD" dialog set the parameter
"Create Test Signal" to Rect and press "Create Test Signal".
The dialog can be used to configure a rectangular test signal. A rectangular test signal
with a duty factor of 0.5 is created. Amplitude and offset are adjustable. Both paths, I and
Q, get the same signal.
Baseband Signal - Baseband Block
To Next Page
Loading...
