Instrument Function
R&S
®
SMU200A
404Operating Manual 1007.9845.32 ─ 15
Blank Segment
The Blank Segment section is where a blank segment can be configured.
Clock Rate
Selects the clock rate of the blank segment.
SCPI command:
n.a.
Samples
Selects the number of samples for the blank segment.
SCPI command:
n.a.
Period
Displays the resulting period for the blank segment.
SCPI command:
n.a.
Append Blank
Adds the blank segment to the multi segment file.
SCPI command:
n.a.
Level / Clock /Marker
The Level/Marker/Clock section provides the parameters necessary to adjust the level,
marker and clock settings for the selected multi segment waveform file.
Level
Defines the level mode for the multi segment waveform.
"Unchanged"
Conserning the level settings, the segments are output exactly as defined
in the files. The "Level" display applies only to the segment with the
highest rms value. In some circumstances the remaining segments are
output at a lower level than that displayed.
"Equal RMS"
Segments are output so that all segments have the same rms value. The
"Level" display applies to all segments.
SCPI command:
n.a.
Clock
Selects the clock rate mode for the multi segment waveform.
"Unchanged"
A segment is output with the clock rate defined in the file.
If segments have different clock rates, extended trigger mode "Next
Segment" allows internal segment switchovers only ("Internal" trigger
source).
Extended trigger mode "Next Segment Seamless" can only be selected
if all segments have the same clock rate.
Baseband Signal - Baseband Block
To Next Page
Loading...
