Instrument Function
R&S
®
SMU200A
405Operating Manual 1007.9845.32 ─ 15
"Highest"
All segments are output at the highest available clock rate.
This mode provides very short switchover times between segments.
The time for calculating the multi segment waveform is increased since
the individual segments have to be resampled.
"User"
All segments are output at the clock rate defined in "User Clock".
This mode provides very short switchover times between segments.
The time for calculating the multi segment waveform is increased since
the individual segments have to be resampled.
SCPI command:
n.a.
User Clock Rate
Defines the sample rate used for multi segment waveform output in case of Clock Mode
"User".
SCPI command:
n.a.
Segment Marker
Defines the way the marker information within the separate segments is processed.
"Ignore"
The marker information carried in the individual segment waveform files
is not considered.
"Take Over"
The output waveform file contains the marker information as configured
in the individual waveform files.
SCPI command:
n.a.
Sequence Restart
Enables/disables the generation of an additional marker restart signal in the output wave-
form file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable"
No additional marker is generated.
"Marker 1/2/3/4"
Generates a restart marker signal at the beginning of the first segment
for the corresponding marker.
Use this setting to generate a restart marker for the complete sequence.
SCPI command:
n.a.
Segment Restart
Enables/disables the generation of an additional marker restart signal in the output wave-
form file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable"
No additional marker is generated.
Baseband Signal - Baseband Block
To Next Page
Loading...
