Instrument Function
R&S
®
SMU200A
406Operating Manual 1007.9845.32 ─ 15
"Marker 1/2/3/4"
Generates a restart marker signal at the beginning of each segment for
the corresponding marker.
The segment begin is defined by the low-high slope of the marker. This
applies for switching between two segments as well as in case of seg-
ment replay.
SCPI command:
n.a.
Output File
In the Output File section, the output file name is specified and a comment can be added
to the file.
Comment
Adds a comment to the multi segment file.
SCPI command:
n.a.
Output file
Opens the File menu, where the file name of the multi segment waveform which has to
be calculated can be entered. The multi segment waveform is saved under this name by
clicking the "Create" or "Create and Load" button.
A name must also be entered here before the list can be saved as a configuration file
("Save List"). In this case the name is needed for internal storage procedures. It is entered
as the default name for the multi segment waveform file when loading the list.
SCPI command:
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:OFILe on page 616
Handling of Multi Segment Files
The buttons in this sections are provided for handling of the multi segment files.
Save List
Saves the current entries of the table in a configuration file, including the level mode,
clock mode, segment marker mode and output file name settings.
The file name is entered in the "File" menu. Configuration files have the file extension
*.inf_mswv. They can be used later as the basis for further multi segment waveforms.
Before a multi segment configuration file can be saved, a file name must be entered in
"Output File", since this is saved with the configuration file for internal purposes.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the command:
[:SOURce<hw>]:BB:ARB:WSEGment:CREate
or [:SOURce<hw>]:BB:ARB:WSEGment:CLOad
The file name of the waveform file is always determined with the command
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:OFILe
SCPI command:
n.a.
Baseband Signal - Baseband Block
To Next Page
Loading...
