Instrument Function
R&S
®
SMU200A
408Operating Manual 1007.9845.32 ─ 15
The file name of the waveform file is always determined with the command
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:OFILe
SCPI command:
[:SOURce<hw>]:BB:ARB:WSEGment:CLOad on page 615
Multi Segment Waveform Sequencing
The settings provided in the "Multi Segment Waveform Sequencing" dialog can be adjus-
ted to crate a “play list”, i.e. to define the sequence in which the waveform file segments
are processed and how many times each of them is repeated. The configured play list is
displayed in form of a "Sequencing Graphic".
All segments in a “play list” must have the same clock rate.
In the "ARB" main dialog or in the "ARB Trigger/Marker/Clock" dialog, set the "Next Seg-
ment Mode" to "Sequencer" to activate the configured “play list”.
Sequencing List
Displays the name of the selected sequencing list file, i.e. the file with the “play list” set-
tings.
The sequencing list file has an extension *.wvs and is automatically assigned to but
independent from the multi segment file. By default, both files have the same name and
are located in the same file directory. More than one sequencing list files can be created
per multi segment waveform file.
The sequencing list file carries information only about the segment number, the corre-
sponding wavefile names are retrieved form the assigned multi segment waveform file,
i.e. the same sequencing list file can be reused for different multi segment waveform files
with the same number of segments.
Changes and re-calculations of a multi segment waveform file cause a re-check whether
the assigned sequencing list files are still valid. A message is displayed to inform about
necessary corrections in the “play list”.
SCPI command:
n.a.
Baseband Signal - Baseband Block
To Next Page
Loading...
