Rohde & Schwarz SMU200A - Page 439

Instrument Function
R&S
®
SMU200A
419Operating Manual 1007.9845.32 ─ 15
Carrier Table Assistant
Number of Carriers
Defines the number of carriers of the multi carrier waveform.
This parameter is identical to that in the "General Setting" section.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:CARRier:COUNt on page 598
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STATe on page 607
Carrier Start
Defines the start index of the carrier range to which the assistant settings are intended
to apply.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STARt on page 607
Carrier Stop
Defines the stop index of the carrier range to which the assistant settings are intended
to apply.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STOP on page 607
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 606
Gain Step
Sets the step width that is used to increment the gain
The resulting carrier gain in the carrier table equals:
GainStart + n* Gain Step
where n ranges from 0 to (Carrier Stop - Carrier Start).
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer:STEP on page 606
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 606
Baseband Signal - Baseband Block