Rohde & Schwarz SMU200A - Page 440

Instrument Function
R&S
®
SMU200A
420Operating Manual 1007.9845.32 ─ 15
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
PhaseStart + n* PhaseStep
where n ranges from 0 to (Carrier Stop – Carrier Start)
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:POWer:STEP on page 606
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:DELay[:STARt]
on page 604
Delay Step
Sets the step width that is used to increment the delay
The resulting delay in the carrier table equals:
DelayStart + n* DelayStep
where n ranges from 0 to (Carrier Stop – Carrier Start).
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:DELay:STEP on page 604
Input Waveform File
Calls the "File" menu for selecting the inputfile with the I/Q signal to be modulated onto
all carriers of the selected carrier range.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:FILE on page 605
Apply Assistant Settings
Transfer the assistant settings to the carrier table.
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:EXECute on page 604
Carrier Table
The table displays the settings of all available carriers. Previously applied assistant set-
tings can be further refined. The number of lines corresponds to the number of carriers.
Note: The phase/deg settings are only valid if optimization of the crest factor is disabled
("Crest Factor Mode" = Off).
Baseband Signal - Baseband Block