Instrument Function
R&S
®
SMU200A
433Operating Manual 1007.9845.32 ─ 15
Trigger Delay
Sets the trigger signal delay in samples on external triggering or on internal triggering via
the second path.
Sets the trigger signal delay in samples on external triggering.
This enables the R&S Signal Generator to be synchronized with the device under test or
other external devices.
For two-path instruments, the delay can be set separately for each of the two paths.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay on page 679
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:DELay on page 677
Trigger Inhibit
Sets the duration for inhibiting a new trigger event subsequent to triggering. The input is
to be expressed in samples.
In the "Retrigger" mode, every trigger signal causes signal generation to restart. This
restart is inhibited for the specified number of samples.
This parameter is only available on external triggering or on internal triggering via the
second path.
For two-path instruments, the trigger inhibit can be set separately for each of the two
paths.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit on page 680
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:INHibit on page 678
Marker Mode
The marker output signal for synchronizing external instruments is configured in the
marker settings section "Marker Mode".
Marker Mode
Selects a marker signal for the associated "MARKER" output.
"Restart"
A marker signal is generated at the start of the waveform.
"Pulse"
A regular marker signal is generated. The pulse frequency is defined by
entering a divider. The frequency is derived by dividing the sample rate
by the divider. The input box for the divider opens when "Pulse" is
selected, and the resulting pulse frequency is displayed below it.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider on page 684
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency
on page 685
"Pattern "
A marker signal that is defined by a bit pattern is generated. The pattern
has a maximum length of 64 bits and is defined in an input field which
opens when pattern is selected.
SCPI command:
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern on page 684
Baseband Signal - Baseband Block
To Next Page
Loading...
