Remote Control Basics
R&S
®
SMU200A
461Operating Manual 1007.9845.32 ─ 15
3. In the "viWrite" tab, write the command to be send to the instrument and select
"Execute".
Instrument responses are displayed on the "viRead" tab.
Tip: For further program operation refer to the online help of the program.
6.2.3.3 Remote Control over LAN using Socket Communication
This chapter provides an example on how to establish a remote control connection over
telnet protocol and a simple sockets-based program example that can be further devel-
oped.
Setting up a Telnet Connection
To control the software, only a telnet program is required. The telnet program is part of
every operating system.
1. To establish a Telnet connection with the R&S SMU, start the telnet program and
enter the socket address.
Starting a Remote Control Session
To Next Page
Loading...
