Preparing for Use
R&S
®
SMU200A
30Operating Manual 1007.9845.32 ─ 15
MONITOR
Connector for external monitor (see chapter 2.4.2, "Connecting a Monitor",
on page 40).
For description of this connector, refer to chapter 1.2, "Monitor Connector (MONITOR)",
on page 838.
AUX I/O
Parallel input/output for data signals as well as settable trigger and control signals of the
baseband.
Input for device trigger.
Assignment of the AUX I/O interface and of USER pins can be configured in the "Setup
> Global Trigger/Clock/External Inputs" and "Setup > USER Marker / AUX I/O Settings".
Use this dialogs to configure also the arbitrary assignment of pins to path A or B.
Note: An adapter of the AUX I/O interface to coaxial BNC connectors is available as an
accessory (R&S SMU-Z5, see data sheet).
See also chapter 5.2.3.10, "Global Trigger/Clock/External Input Settings", on page 137
and chapter 5.2.3.12, "User Marker / AUX I/O Settings", on page 140.
For detailed description of the AUX I/O connector, refer to chapter 1.1, "AUX I/O Con-
nector", on page 837.
BERT
Input for data, clock and control signals for bit and block error rate measurements, level
0.0128..1.998V.
BASEBAND DIGITAL IN/OUT
Digital Interface:
●
Input for external digital I/Q signal (BBIN) in case of digital modulation (option R&S
SMU-B17, Baseband Input (digital/analog)).
●
Output of the digital I/Q signal (BBOUT) (option R&S SMU-B18 Digital I/Q Out).
LAN CONNECTOR
Ethernet interface
●
For integrating signal generators in a network
●
Remote control of signal generator
●
Input of external asynchronous data
●
Remote access to the signal generator
●
Firmware update
See also:
●
chapter 2.6, "Setting Up a Network (LAN) Connection", on page 42
●
chapter 6.1.3, "LAN Interface", on page 451
RF A / RF B
Rear Panel Connectors for path A (option R&S SMU-B81) and path B (option R&S SMU-
B82). This options are recommended for use of the instrument in a 19" rack. Installing
the instrument in a 19" rack requires a rack adapter or an adapter for telescopic sliders
(refer to data sheet for order number).
See also chapter 2.3.2, "Placing or Mounting the Instrument", on page 33.
Rear Panel Tour
To Next Page
Loading...
