Rohde & Schwarz SMU200A - Page 548

Remote Control Commands
R&S
®
SMU200A
528Operating Manual 1007.9845.32 ─ 15
:DIAGnostic:INFO:POCount............................................................................................529
:DIAGnostic<hw>:BGINfo?
The command checks the modules available in the instrument using the variant and revi-
sion state.
If the command is sent without parameters being specified, a complete list of all modules
is returned (the various entries are separated by commas). The length of the list is variable
and depends on the instrument equipment configuration.
If the command is sent with parameters, a list of the specified modules is returned (the
various entries are separated by commas). A list of modules names can be called up
using the command :DIAGnostic<hw>:BGINfo:CATalog on page 528.
Each entry for one module consists of four parts which are separated by space charac-
ters:
< Module name> <Module stock number incl. variant> <Module revision> <Module serial
number>
For two-path instruments, the path for which the query is performed is determined by the
numerical suffix.
Return values:
string
<Bginfo>
DIAG:BGIN
Queries the instrument configuration.
Response: MBRD,SSYN,IQOP3,IQOP3_LCM,....
returns the data of all available modules.
DIAG:BGIN? 'MBRD'
Queries the configuration of the motherboard.
Response: MBRD 1141.3501.02 1.5.3 100023
Module motherboard with stock number 1141.3501.01 has revi-
sion 1.5.3 and serial number 100023.
Example:
Query onlyUsage:
:DIAGnostic<hw>:BGINfo:CATalog?
The command queries the names of the assemblies available in the instrument.
A complete list of all assemblies is returned (the various entries are separated by com-
mas). The length of the list is variable and depends on the instrument equipment con-
figuration.
For two-path instruments, the path for which the query is performed is determined by the
numerical suffix.
Return values:
string<Catalog>
DIAGnostic Subsystem