Rohde & Schwarz SMU200A - Hcopy:printer:list; Hcopy:printer:page:margins; Hcopy:printer[:Name]

Remote Control Commands
R&S
®
SMU200A
539Operating Manual 1007.9845.32 ─ 15
HCOP:IMAG:FORM XPM
selects the image format XPM.
Example:
:HCOPy:IMAGe:SIZE <Size>
The command selects the image size of the hardcopy. The first value of the size setting
defines the width, the second value the height of the image.
Parameters:
320,640|640,480|800,600|1024,768
depends on device
<Size>
*RST:
HCOP:IMAG:SIZE 640,480
sets width and height of the image.
Example:
:HCOPy:PRINter:LIST?
The command queries the available printers. If the list is empty, no printer driver is instal-
led.
Return values:
string<List>
HCOP:PRIN:LIST?
returns a list of the available printers.
Example:
Query onlyUsage:
:HCOPy:PRINter[:NAME] <Name>
The command selects the printer.
Parameters:
string<Name>
HCOP:PRIN:NAME "printer1"
selects printer printer1.
Example:
:HCOPy:PRINter:PAGE:MARGins <Margins>
The command defines the margins of the paper for printing the hardcopy. The values are
entered in the sequence <top,bottom,left,right>, the values are separated by commas. A
dot is used as decimal separator. Depending on the set physical unit by the parameter
Unit, width and height are expressed in cm or inches.
Parameters:
2.5,2.5,2.5,2.5
<Margins>
*RST:
HCOPy Subsystem