Remote Control Commands
R&S
®
SMU200A
547Operating Manual 1007.9845.32 ─ 15
:MMEMory:CDIRectory <Cdirectory>
Changes the default directory for mass memory storage. The directory is used for all
subsequent MMEM commands if no path is specified with them. It is also possible to
change to a higher directory using two dots '..' .
Setting parameters:
<directory_name><Cdirectory>
MMEM:CDIR 'test'
changes from the current directory level to the subdirectory 'test'.
Example:
Setting only
SCPI conform
Usage:
:MMEMory:COPY <file_source>[,<file_destination>]
Copies an existing to a new file. Instead of just a file, this command can also be used to
copy a complete directory together with all its files.
It is also possible to specify the path using another parameter. The command is:
MMEMory:COPY
<file_source><msus_source>[,<file_destination>,
<msus_destination>]
Setting parameters:
string
String parameter to specify the name of the file to be copied.
If <destination> is not specified, <source> is copied to the
MMEM:MSIS drive and the MMEM:CDIR directory. Files which
already exist with the same name in the destination directory are
overwritten without an error message.
It is also possible to specify the path using another parameter. The
command is: MMEMory:COPY
<file_source><msus_source>[,<file_destination>,
<msus_destination>]
string
String parameter to specify the name of the new file. If no file
destination is specified, the source file is copied to the current
direcotry, queried with the MMEM:CDIR command. Files which
already exist with the same name in the destination directory are
overwritten without an error message.
<file_source>
file_destination
MMEM:COPY 'D:/USER/TEST1.SVARCL','E:'
copies the file 'test1.savrcl' in the USER directory on the
internal hard disk to the memory stick without changing the file
name.
Example:
Event
SCPI conform
Usage:
MMEMory Subsystem
To Next Page
Loading...
