Rohde & Schwarz SMU200A - 7.13 Output Subsystem; Output<Hw>:Afixed:range:lower; Output Subsystem

Remote Control Commands
R&S
®
SMU200A
552Operating Manual 1007.9845.32 ─ 15
*SAV 4
stores the current instrument setting in an intermediate memory
with number 4. This setting can be called using command *RCL
and the associated number of the memory, e.g. *RCL 4.
MMEM:STOR:STAT 4,'D:/user/test4.savrcl'
stores the instrument setting stored with the *SAV command under
memory number 4 in the file test4.savrcl in the user direc-
tory.
Example:
EventUsage:
7.13
OUTPut Subsystem
The OUTPut system contains the commands which set the properties of the RF OUT-
PUT connectors and USER connectors. The properties of the LF output connector are
set in the chapter 7.15.11, "SOURce:LFOutput Subsystem", on page 739 system.
In two-path instruments with a second path, the properties can be set separately and
independently for the two outputs A and B.
:OUTPut:ALL[:STATe]....................................................................................................552
:OUTPut<hw>:AFIXed:RANGe:LOWer.............................................................................552
:OUTPut<hw>:AFIXed:RANGe:UPPer..............................................................................553
:OUTPut<hw>:AMODe...................................................................................................553
:OUTPut<hw>:BLANk:LIST:STATe..................................................................................554
:OUTPut:BLANk:POLarity...............................................................................................554
:OUTPut<hw>:IMPedance..............................................................................................555
:OUTPut<hw>:PROTection:CLEar...................................................................................555
:OUTPut<hw>:PROTection:STATe..................................................................................555
:OUTPut<hw>:PROTection:TRIPped................................................................................556
:OUTPut<hw>[:STATe]...................................................................................................556
:OUTPut<hw>[:STATe]:PON...........................................................................................556
:OUTPut:USER<ch>:SOURce.........................................................................................557
:OUTPut:ALL[:STATe] <State>
The command switches on or off all RF output signals of the instrument.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
OUTP:ALL OFF
switches off all RF output signals.
Example:
:OUTPut<hw>:AFIXed:RANGe:LOWer?
The command queries the minimum level which can be set without the attenuator being
adjusted (Attenuator FIXed).
OUTPut Subsystem