Rohde & Schwarz SMU200A - Page 604

Remote Control Commands
R&S
®
SMU200A
584Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:ARB:TRIGger:EXECute.....................................................................584
[:SOURce<hw>]:BB:ARB:TRIGger:EXTernal:SYNChronize:OUTPut...................................585
[:SOURce<hw>]:BB:ARB:TRIGger:OBASeband:DELay.....................................................585
[:SOURce<hw>]:BB:ARB:TRIGger:OBASeband:INHibit.....................................................586
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut:DELay:FIXed..................................................586
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay....................................................586
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MAXimum....................................587
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MINimum......................................587
[:SOURce<hw>]:BB:ARB:TRIGger:RMODe......................................................................587
[:SOURce<hw>]:BB:ARB:TRIGger:SLENgth.....................................................................588
[:SOURce<hw>]:BB:ARB:TRIGger:SLUNit........................................................................588
[:SOURce<hw>]:BB:ARB:TRIGger:SMODe......................................................................589
[:SOURce<hw>]:BB:ARB:TRIGger:SOURce.....................................................................589
[:SOURce<hw>]:BB:ARB:TRIGger[:EXTernal<1|2>]:DELay................................................590
[:SOURce<hw>]:BB:ARB:TRIGger[:EXTernal<1|2>]:INHibit................................................590
[:SOURce<hw>]:BB:ARB[:TRIGger]:SEQuence................................................................591
[:SOURce<hw>]:BB:ARB:TRIGger:ARM:EXECute
The command stops waveform output for trigger modes Armed_Auto and Armed_Ret-
rigger. A subsequent internal or external trigger event restart waveform output.
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:TRIG:SEQ ARET
sets Armed_Retrigger mode, i.e. every trigger event causes wave-
form output to restart.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started.
BB:ARB:TRIG:ARM:EXEC
waveform output is stopped.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started again.
Example:
EventUsage:
[:SOURce<hw>]:BB:ARB:TRIGger:EXECute
The command executes a trigger. The internal trigger source must be selected using the
command ARB:TRIGger:SOURce INTernal and a trigger mode other than AUTO must
be selected using the command :ARB:SEQuence.
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:SEQ RETR
sets Retrigger mode, i.e. every trigger event causes signal output
to restart.
BB:ARB:TRIG:EXEC
executes a trigger.
Example:
EventUsage:
SOURce Subsystem