Remote Control Commands
R&S
®
SMU200A
589Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:ARB:TRIGger:SMODe <Smode>
The command selects the extended trigger mode for multi segment waveforms.
Parameters:
SAME|NEXT|NSEam|SEQuencer
SAME
The currently selected segment is output repeatedly.
NEXT
The current segment ceases to be output as soon as a new
segment is entered with command :BB:ARB:WSEG:NEXT and the
new segment starts to be output after a system-imposed signal
gap.
NSEam
The segment selected with command :BB:ARB:WSEG:NEXT is
not output until the whole of the current segment has been output
(wrap around). In this case the signal transition is seamless.
SEQuencer
The waveform files are processed according to the order and
repetition cycles defined in the special sequencing list file
(*.wvs) assigned to the multi segment waveform file.
This “play list” is selected with the command
BB:ARB:WSEG:SEQ:SEL.
NEXT
<Smode>
*RST:
SOUR2:BB:ARB:SEQ AUTO
selects trigger mode AUTO.
SOUR2:BB:ARB:TRIG:SMOD SAME
the same segment of the waveform is output repeatedly.
Example:
[:SOURce<hw>]:BB:ARB:TRIGger:SOURce <Source>
The command selects the trigger source.
SOURce Subsystem
To Next Page
Loading...
