Rohde & Schwarz SMU200A - Test Signals Settings

Remote Control Commands
R&S
®
SMU200A
594Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:PULSe:FREQuency?
The command queries the pulse frequency of the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived by
dividing the symbol rate by the divider. The divider is defined with com-
mand :BB:ARB:TRIG:OUTP:PULS:DIV.
Return values:
float<Frequency>
BB:ARB:TRIG:OUTP2:PULS:DIV 4
sets the divider for the marker signal on output MARKER 2 to the
value 4.
BB:ARB:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:ARB:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 33 000
the resulting pulse frequency is 33 kHz.
Example:
Query onlyUsage:
Test Signals Settings
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate................................................................594
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate.....................................................594
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate...............................................................594
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate:NAMed.....................................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate:NAMed..........................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate:NAMed...................................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:I...........................................................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:Q.........................................................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:AMPLitude.................................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:FREQuency...............................................595
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:OFFSet.....................................................596
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:SAMPles...................................................596
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:FREQuency........................................................596
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:PHASe...............................................................597
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:SAMPles.............................................................597
[:SOURce<hw>]:BB:ARB:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARB:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARB:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
BB:ARB:TSIG:SINE:CRE
generates a test sine signal and uses it as output straight away.
Example:
EventUsage:
SOURce Subsystem