Rohde & Schwarz SMU200A - Page 627

Remote Control Commands
R&S
®
SMU200A
607Operating Manual 1007.9845.32 ─ 15
Parameters:
float
-80 to 0
0.01
0
dB
<Start>
Range:
Increment:
*RST:
Default unit:
BB:ARB:MCAR:EDIT:CARR:POW -50 dB
sets the power of the carriers in the carrier range to -50 dB.
Example:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STARt <Start>
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STOP <Stop>
The command selects the last carrier in the carrier range to which the settings with
the :BB:ARB:MCAR:EDIT:CARR:.. commands shall apply.
Parameters:
float
0 to 31
0
<Stop>
Range:
*RST:
BB:ARB:MCAR:EDIT:CARR:STOP 4
the carrier range stops at carrier 4.
Example:
[:SOURce<hw>]:BB:ARB:MCARrier:EDIT:CARRier:STATe <State>
The command switches all the carriers in the selected carrier range on or off.
Parameters:
0|1|OFF|ON
ON
<State>
*RST:
BB:ARB:MCAR:EDIT:CARR:STAT ON
sets all the carriers in the carrier range to ON.
Example:
[:SOURce<hw>]:BB:ARB:MCARrier:OFILe <Ofile>
This command defines the output file name for the multi carrier waveform. This file name
is used when a waveform is calculated (command SOUR:BB:ARB:MCAR:CLOad or
SOUR:BB:ARB:MCAR:CREate). The file extension is *.wv.
Parameters:
<file name><Ofile>
SOURce Subsystem