Rohde & Schwarz SMU200A - Page 628

Remote Control Commands
R&S
®
SMU200A
608Operating Manual 1007.9845.32 ─ 15
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:MCAR:OFIL 'mcar1_2'
defines the file name mcar1_2.wv for the multi carrier waveform
file
Example:
[:SOURce<hw>]:BB:ARB:MCARrier:PRESet
The command sets all ARB multi carrier parameters to their default values.
BB:ARB:MCAR:PRES
resets the ARB multi carrier parameters to default values.
Example:
EventUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:SAMPles?
The command queries the resulting file size. The file size is returned in samples.
Return values:
float<Samples>
BB:ARB:MCAR:SAMP?
queries the file size of the currently calculated multi carrier wave-
form.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:CATalog?
This command queries the available settings files in the specified default directory. The
settings files are used to set the ARB multi carrier submenu. Only files with the file exten-
sion *.arb_multcarr will be listed.
Return values:
string<Catalog>
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:MCAR:SETT:CAT?
reads out all the settings files in the default directory.
Response: mcar1, mcar2
the directory contains the configuration files mcar1.arb_mult
carr and mcar2.arb_multcarr.
Example:
Query onlyUsage:
SOURce Subsystem