Rohde & Schwarz SMU200A - Page 629

Remote Control Commands
R&S
®
SMU200A
609Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:LOAD <Load>
The command loads the settings file. If a settings file with the specified name does not
yet exist, it is created. The file extension may be omitted. Only files with the file extension
*.arb_multcarr will be loaded or created.
Setting parameters:
<file_name><Load>
BB:ARB:MCAR:SETT:LOAD 'D:/user/waveform/new'
creates settings file new.arb_multcarr.
Example:
Setting onlyUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:STORe <Store>
The command stores the current settings of submenu "Multi Carrier" in a file in the speci-
fied directory. The file extension may be omitted, the files are stored with the file extension
*.arb_multcarr.
Setting parameters:
string<Store>
BB:ARB:MCAR:SETT:STOR 'D:/user/waveform/mcarr2'
stores settings file mcarr2.arb_multcarr in the default direc-
tory.
Example:
Setting onlyUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:TIME <Time>
The command sets the user-defined signal period. This setting is only possible for Signal
Period Mode User (BB:ARB:MCAR:TIME:MODE USER).
Parameters:
float
1E-12s to 1E9s
0
s
<Time>
Range:
*RST:
Default unit:
BB:ARB:MCAR:TIME:MODE USER
selects Signal Period Mode User.
BB:ARB:MCAR:TIME 10 s
sets a signal period of 10 seconds
Example:
[:SOURce<hw>]:BB:ARB:MCARrier:TIME:MODE <Mode>
The command selects the mode for calculating the resulting signal period of the multi
carrier waveform. The resulting period is always calculated for all carriers in the carrier
table irrespective of their state (ON/OFF).
SOURce Subsystem