Rohde & Schwarz SMU200A - Page 632

Remote Control Commands
R&S
®
SMU200A
612Operating Manual 1007.9845.32 ─ 15
Setting parameters:
#<length of the length field><length field><block of binary data>
# is always used to introduce the binary block,
<length field> defines the number of bytes in the <block of binary
data>,
<length of the length field> states the length of the <length fild>,
<block of binary data> is the binary block data of the specified
length.
Example: #234<block of binary data> In this example the digit 2
states that the length field occupies two positions and the following
two digits determine that the length of the binary block is 34 bytes.
Query parameters:
'comment' | 'copyright' | 'date' | 'lacpfilter' | 'marker name' |
'poweroffset'
Parameters for setting and query:
Specifies the name of the wavefile in that the binary data will be
copied. Waveform data is stored only in files with the specific file
extensions *.wv.
<binary data block>
<tag>
<waveform filename>
Setting
BB:ARB:WAV:DATA 'D:/user/TEST1.WV',#3767<bin
data block>
writes the block data to file 'test1.wv' in the D:/user directory.
Query
BB:ARB:WAV:DATA? 'D:/user/TEST1.WV','comment'
queries the content of the 'comment' tag of file wave1.wv in the
user directory
Response: "Sine wave for test purposes"
Example:
Example:
[:SOURce<hw>]:BB:ARB:WAVeform:DELete <Delete>
The command deletes the specified waveform file. If the file is not on the default path,
the path must be specified at the same time. The file extension may be omitted. Only files
with the file extension *.wv will be deleted.
Setting parameters:
<waveform filename><Delete>
BB:ARB:WAV:DEL 'D:/user/wave1.wv'
deletes waveform file wave1.wv.
Example:
Setting onlyUsage:
[:SOURce<hw>]:BB:ARB:WAVeform:FREE?
The command queries the free disk space on the default path of the instrument's harddisk.
SOURce Subsystem