Rohde & Schwarz SMU200A - Page 650

Remote Control Commands
R&S
®
SMU200A
630Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay:MINimum?
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay:MAXimum?
The command queries the maximum marker delay for set-
ting :BB:DM:TRIG:OUTP:DEL:FIX ON.
Return values:
float<Maximum>
BB:DM:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
BB:DM:TRIG:OUTP:DEL:MAX
queries the maximum of the dynamic range.
Response: 2000
the maximum for the marker delay setting is 2000 symbols.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:DM:TRIGger:RMODe?
The command displays the status of signal generation for all trigger modes with digital
modulation on.
Return values:
STOP|RUN
RUN
The signal is generated. A trigger event occurred in the triggered
mode.
STOP
The signal is not generated. A trigger event did not occur in the
triggered modes, or signal generation was stopped by the
command :BB:DM:TRIG:ARM:EXECute (armed trigger modes
only).
<Rmode>
BB:DM:TRIG:SOUR EXT
sets external triggering via the TRIGGER 1 connector.
BB:DM:TRIG:MODE ARET
selects the Armed_Retrigger mode
BB:DM:TRIG:RMOD?
queries the current status of signal generation.
Response: RUN
the signal is generated, an external trigger was executed.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:DM:TRIGger:SLENgth <Slength>
The command defines the length of the signal sequence to be output in the "Single" trigger
mode.
SOURce Subsystem