Rohde & Schwarz SMU200A - Page 677

Remote Control Commands
R&S
®
SMU200A
657Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER...................................................................658
[:SOURce<hw>]:BB:GRAPhics:STATe.............................................................................658
[:SOURce<hw>]:BB:GRAPhics:TRIGger:SOURce.............................................................658
[:SOURce<hw>]:BB:GRAPhics:MODE <Mode>
Selects the graphical signal display.
Parameters:
IQ|VECTor|CCDF|PSPectrum|CONStellation|EYEI|EYEQ
IQ
<Mode>
*RST:
BB:GRAP:MODE VECT
selects vector diagram.
Example:
[:SOURce<hw>]:BB:GRAPhics:SMARt:STATe <State>
Activates/deactivates the "smart graphics".
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
BB:GRAP:SMAR:STAT ON
Activates smart graphics.
Example:
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE <Mode>
Sets how the time resolution of the signal is determined. Maximum resolution corre-
sponds to a display covering the entire signal bandwidth. The higher the resolution is, the
shorter the length of the displayed signal segment will be for the specified recording
depth.
Parameters:
AUTO|FULL|USER
AUTO
The resolution is set to an optimum value on the basis of the signal
and display type.
FULL
The resolution is set such that the display covers the entire signal
bandwidth.
USER
with the command SOUR:BB:GRAP:SRAT:USER, the user can
determine the resolution by setting the signal bandwidth for which
the display is to be generated
AUTO
<Mode>
*RST:
BB:GRAP:SRAT:MODE FULL
sets the sample rate mode.
Example:
SOURce Subsystem