Rohde & Schwarz SMU200A - Page 685

Remote Control Commands
R&S
®
SMU200A
665Operating Manual 1007.9845.32 ─ 15
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:FREQuency:
OFFSet?
Note: Frequency offset of the user correction data is only indicated if the instrument is
equipped with an R&S SMx-K63 and external devices are enabled.
The command displays the frequency offset value of the frequency response correction
data.
Return values:
float<Offset>
SOURce:BB:IMP:OPT:UCOR:FREQ:OFFS?
queries the frequency offset of the correction data.
Response: xxxx.x MHz
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:IAFixed?
Note: The status of the correction file is only indicated if the instrument is equipped with
an R&S SMx K63.
The command displays the status of the attenuator, included in the baseband frequency
response correction data. When the operating mode Fixed is switched on, the attenuator
is fixed in its current position and the resulting variation range is defined.
Return values:
0|1|OFF|ON<Iafixed>
SOURce:BB:IMP:OPT:UCOR:FREQ:IAF?
queries the status (enabled / disabled) of the attenuator.
Response: ON | OFF
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:LEVel:MAX?
Note: Level values of the user correction data are only indicated if the instrument is
equipped with an R&S SMx-K63.
The command displays the maximum level value of the baseband frequency response
correction data.
Return values:
float<Max>
SOURce:BB:IMP:OPT:UCOR:LEV:MAX?
queries the maxinimum signal level of the correction data.
Response: uu dB
Example:
SOURce Subsystem