Rohde & Schwarz SMU200A - Page 686

Remote Control Commands
R&S
®
SMU200A
666Operating Manual 1007.9845.32 ─ 15
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:LEVel:MIN?
Note: Level values of the user correction data are only indicated if the instrument is
equipped with an R&S SMx-K63.
The command displays the minimum level value of the baseband frequency response
correction data.
Return values:
float<Min>
SOURce:BB:IMP:OPT:UCOR:LEV:MIN?
queries the minimum signal level of the correction data.
Response: vv dB
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:LEVel:OFFSet?
Note: Level offset of the user correction data is only indicated if the instrument is equipped
with an R&S SMx-K63 and external devices are enabled.
The command displays the level offset value of the baseband frequency response cor-
rection data.
Return values:
float<Offset>
SOURce:BB:IMP:OPT:UCOR:LEV:OFFS?
queries the signal level offset of the correction data.
Response: uu dB
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:IMPairment:OPTimization:UCORrection:TYPE?
Note: The user correction type is only indicated if the instrument is equipped with an R&S
SMx-K63.
The command displays type of the baseband frequency response correction data.
Return values:
RFResponse|RFImage|RFRImage<Type>
SOURce:BB:IMP:OPT:UCOR:TYPE?
queries the type of the correction data.
Response: RFResponse | RFImage | RFRImage
Example:
Query onlyUsage:
SOURce Subsystem