Rohde & Schwarz SMU200A - Page 700

Remote Control Commands
R&S
®
SMU200A
680Operating Manual 1007.9845.32 ─ 15
Parameters:
0 to 2^32-1
0
<Delay>
Range:
*RST:
BB:MCCW:TRIG:SOUR EXT
selects an external trigger via the TRIGGER 1 connector.
BB:MCCW:TRIG:DEL 50
sets a delay of 50 symbols for the trigger.
Example:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:INHibit <Inhibit>
The command specifies the number of symbols/samples by which a restart is to be
inhibited following a trigger event. This command applies only in the case of external
triggering.
Parameters:
0 to 2^26-1
1
0
<Inhibit>
Range:
Increment:
*RST:
BB:MCCW:TRIG:SOUR EXT
selects an external trigger via the TRIGGER 1 connector.
BB:MCCW:TRIG:INH 200
sets a restart inhibit for 200 symbols following a trigger event.
Example:
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:SYNChronize:OUTPut
<Output>
(enabled for Trigger Source External)
Enables/disables output of the signal synchronous to the external trigger event.
See "Sync. Output to External Trigger" on page 432.
Parameters:
0|1|OFF|ON<Output>
BB:MCCW:TRIG:SYNC:OUTP ON
Example:
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence <Sequence>
Selects the trigger mode.
SOURce Subsystem