Rohde & Schwarz SMU200A - Page 705

Remote Control Commands
R&S
®
SMU200A
685Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal in the set-
ting :BB:MCCW:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived by
dividing the symbol/sample rate by the divider. The divider is defined with com-
mand :BB:MCCW:TRIG:OUTP:PULS:DIV.
Return values:
float<Frequency>
BB:MCCW:TRIG:OUTP2:PULS:DIV 2
sets the divider for the marker signal on output MARKER 2 to the
value 2.
BB:MCCW:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:MCCW:TRIG:OUTP2:FREQ?
queries the resulting pulse frequency of the marker signal.
Response: 66 000
the resulting pulse frequency is 66 kHz.
Example:
Query onlyUsage:
Clock Settings
[:SOURce<hw>]:BB:MCCW:CLOCk:MODE......................................................................685
[:SOURce<hw>]:BB:MCCW:CLOCk:MULTiplier................................................................686
[:SOURce<hw>]:BB:MCCW:CLOCk:SOURce...................................................................686
[:SOURce<hw>]:BB:MCCW:CLOCk:MODE <Mode>
The command enters the type of externally supplied clock (:BB:MCCW:CLOC:SOUR
EXT).
For two-path instruments, the only numerical suffix allowed for SOURce is 1, since the
external clock source is permanently allocated to path A.
Parameters:
SAMPle|MSAMple
When MSAMple is used, a multiple of the sample clock is supplied
via the CLOCK connector and the sample clock is derived
internally from this. The multiplier is entered with the
command :BB:MCCW:CLOCk:MULTiplier.
SAMPle
<Mode>
*RST:
BB:MCCW:CLOC:MODE SAMP
selects clock type Sample, i.e. the supplied clock is a sample
clock.
Example:
SOURce Subsystem