Remote Control Commands
R&S
®
SMU200A
705Operating Manual 1007.9845.32 ─ 15
CORR:DEXC:MODE EXP
selects that the user correction list is exported into an ASCII file.
CORR:DEXC:AFIL:SEL 'D:
/user/ucor/import/ucor.csv'
selects ASCII file ucor.csv as destination for the user correction
list data.
CORR:DEXC:AFIL:SEP:COL TAB
the pairs of frequency and level values are separated by a tabu-
lator.
CORR:DEXC:AFIL:SEP:DEC DOT
selects the decimal separator dot.
CORR:DEXC:SEL 'D:/user/ucor/import/ucor_imp'
selects that the user correction list ucor_imp is imported into ASCII
file ucor.csv.
Example:
[:SOURce<hw>]:CORRection:DEXChange:EXECute
The command starts the export or import of the selected file. When import is selected,
the ASCII file is imported as user correction list. When export is selected, the user cor-
rection list is exported into the selected ASCII file.
CORR:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into user correction lists.
CORR:DEXC:AFIL:SEL 'D:
/user/ucor/import/ucor.csv'
selects that ASCII file ucor.csv is imported.
CORR:DEXC:SEL 'D:/user/ucor/import/ucor_imp'
selects that the ASCII file ucor.csv is imported into user correction
list ucor_imp.
CORR:DEXC:EXEC
starts the import of the ASCII file data into the user correction file.
Example:
EventUsage:
[:SOURce<hw>]:CORRection:DEXChange:MODE <Mode>
The command selects if user correction lists should be imported or exported. Depending
on the selection her, the file select command define either the source or the destination
for user correction lists and ASCII files.
Parameters:
IMPort|EXPort
IMPort
<Mode>
*RST:
SOURce Subsystem
To Next Page
Loading...
