Rohde & Schwarz SMU200A - Source:fm Subsystem

Remote Control Commands
R&S
®
SMU200A
707Operating Manual 1007.9845.32 ─ 15
EventUsage:
[:SOURce<hw>]:CORRection:MLEVel:STATe <State>
The command activates the use of multi level data for user correction. The setting is only
available for user correction list with multi level correction data (see command
SOUR:CORR:CSET:DATA:POW:MLEV:STAT ON).
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
SOUR:CORR:MLEV:STAT ON
activates the use of multi level correction data for user correction.
Example:
[:SOURce<hw>]:CORRection[:STATe] <State>
The command activates/deactivates level correction. Level correction is performed using
the table which has been selected with the command CORRection:CSET:SELect.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
SOUR2:CORR:CSET 'ucor1'
selects the table ucor1 for RF output B.
SOUR2:CORR ON
activates user correction for RF output B.
Example:
[:SOURce<hw>]:CORRection:VALue?
The command requests the current value for user correction.
Return values:
float<Value>
CORR:VAL?
queries the value currently used for level correction.
Response: -3
the correction value is - 3 dB.
Example:
Query onlyUsage:
7.15.6 SOURce:FM Subsystem
The FM subsystem contains the commands for checking the frequency modulation. The
settings for the internal modulation source (LF generator) are made in the
SOURce:LFOutput subsystem.
SOURce Subsystem